You are here: Home > Other Effects Manufacturers M-Z > Z. Vex (Click here for Full List) > Power Plates
Sort By:
Page of 1
ZVex Power Plate (AC Adaptor) small ZVex Power Plate (AC Adaptor) large
Analog Man carries the ZVex Power Plate (AC Adaptor) small. In response to overwhelming requests for modifications to Z.Vex pedals for use with A.C. power supplies, we are now offering retrofit plates that you may use with any Z.Vex pedal that allow connection to a standard Boss-type (5.5mm X 2.1mm barrel-type) A.C. power supply. In response to overwhelming requests for modifications to Z.Vex pedals for use with A.C. power supplies, we are now offering retrofit plates that you may use with any Z.Vex pedal that allow connection to a standard Boss-type (5.5mm X 2.1mm barrel-type) A.C. power supply.
   
 
Power Plates (AC Adaptors)
 
In response to overwhelming requests for modifications to Z.Vex pedals for use with A.C. power supplies, we are now offering retrofit plates that you may use with any Z.Vex pedal that allow connection to a standard Boss-type (5.5mm X 2.1mm barrel-type) A.C. power supply.

Some notes:

Remove your original bottom plate, and put it away for safekeeping. Remove the battery from the effect and clip the battery clip from the Power Plate to the battery clip in the effect. Put some tape (electrical tape is best, but anything will do) on the connectors so they don't short against anything inside your pedal. Tuck the power supply filter and the clips into the area where the battery goes and make sure they don't cause anything to break while screwing the plate in place with the original screws. You can angle the umbilical cord in any direction to head toward your power supply. This power supply adapter works well with any type of D.C. power system, even daisy chain, because it contains its own filtering and polarity protection system.

The small plates will also work with old MXR and some other similar sized pedals!